Overhead view — completed interior with Yamaha four-stroke outboard

Port-side view — teak trim detail and custom woodwork

Bow angle — classic hull stripe and teak bench seats

Starboard quarter — full build on trailer, ready to launch

Cockpit — access hatch open, throttle console and battery setup

Bow — navigation lights lit, port and starboard

Looking aft — teak bench seats and helm from the bow

Looking aft — original interior with deteriorated floor panels and bench seat

Port side — original hull graphics, stained interior and rotted floor

Teardown — rotted floor sections cut out, exposing the old structure underneath

Floor opened up — looking toward the bow with the old material removed

Amidships — floor cut back to the hull, ready for new glass work

In the shop — interior stripped back with fresh fiberglass laid in the floor channel

Transom area — ground back and glassed, spray gun staged for finish coats

Finished interior — speckled finish cured, shot from the port side in the shop

Looking forward — new floor, seat and bow platform fully refinished

Overhead from the stern — seat, bow platform and finished floor

Bow-ward view — finish complete with the hull masked off

Full length, stern to bow — clean, seamless interior

On the water — bow quarter with the Yamaha four-stroke on the transom

Side profile — fresh paint, dark rub rail and finished interior

Bow view — cleat, oar and speckled interior

Looking aft — bench seat, fuel tank and outboard from the bow

Finished and afloat